MegaSquirtPNP G2 NS8994 for the 89-94 Nissan 240SX, manual trans

MegaSquirtPNP Gen 2 Plug-N-Play Standalone Engine Management System MegaSquirtPNP Model #NS8994 Features 1989-1994 Nissan 240SX KA24E or KA24DE w/ manual tranny Also fits the following USDM applications (all with manual tranny): 1991-1994 Nissan Sentra / NX1600 / NX2000 with GA16DE or SR20DE
1991-1993 Infiniti G20 with SR20DE
1990-1995 D21 Hardbody pickup with KA24E
1993-1994 Altima with KA24DE
New second generation MSPNP! We've totally redesigned the MSPNP! This new second generation unit runs MS2/Extra sequential code, using the MicroSquirt Module and a lot of new MSPNP-specific hardware. We've added several major improvements over the original. Here's the features of the new model. Easy to Use and Install! Fully Plug and Play Installation - No wiring required for basic functionality. Average install time is under 1 hour! KA24 base maps is pre-loaded to help your engine start on the first turn of the key (other model base maps included on CD)
Real time tuning and data logging with a laptop connection
Supports most aftermarket wideband sensors
Fully Tunable Engine Control! 16x16 Fuel Tables allow high resolution tuning
12x12 Ignition Tables
Multiple Acceleration enrichment strategies
Closed Loop Idle Speed Control
Air Conditioner Control
Up to 4 sequential fuel injector channels with individual trim tables (optional trigger disc required for sequential injection)
Onboard peak and hold drivers support both high and low impedance injectors - No external ballast resistor is needed!
Allows removal of stock airflow meter
Advanced Feature Set (Included!) 12x12 Air Fuel Ratio Target Tables for use with wide band O2 sensor for precise tuning and table trim.
Built-in 2-step rev limiter / launch control with flat shift
Real time barometric correction
Internal 4-bar MAP sensor reads up to 44PSI of boost
Overboost protection
Closed loop boost control (Requires DIYAutoTune.com EBC solenoid kit)
Knock sensor input with adjustable sensitivity
Headphone output for knock sensor - listen for knock while you tune!
Table switching input. Change fuel and spark maps on the fly for different fuels, nitrous activation, etc.
Input for flex fuel sensor - switch between E85 and gasoline on the fly!
CANBus connector allows interconnection of other MegaSquirt-compatible devices for additional functions (EGT Input, Automatic Transmission Controller, Additional Sensors.....the possibilities are limitless! Note: Many of these models do not have an IAT (Intake Air Temperature) sensor from the factory. On these cars, we strongly recommend installing a GM IAT to allow for air temperature correction. What you get in the box: MegaSquirtPNP NS8994 ECU MSPNP RS232 serial tuning cable, 6' (USB adapter sold separately, if needed) Tuning Software and Documentation CD 6' Vacuum Hose for MAP Signal and 'T' fitting Four Screws for ECU mounting